310 L4-1488cc 1.5L SOHC (E15S) (1982)
Technical Service Bulletin # TS82019
Date: 820301
Fuel System - Service Specification Revisions
TS82-019
March 1, 1982
Engine Fuel
ENGINE FUEL, 310 A/T
Applied Model:
310 series with automatic transaxle
This bulletin contains data for the automatic transaxle equipped 310 model omitted from the previously issued 1982 DATSUN 310 SERVICE
MANUAL.
Paste each of these pages over the same pages in your manual. Just dampen the backs of the attached pages.
See pages EF14-15 previously issued 310 Service Manual.
INSPECTION AND ADJUSTMENT
CARBURETOR IDLE RPM AND MIXTURE RATIO (U.S.A.)
The idle mixture adjusting screw which has been preset at the factory should be adjusted only in the event of a major carburetor overhaul, throttle body
replacement or to lower exhaust emissions as directed by official inspections. The plug which seals this screw
should not be removed during routine maintenance. Adjusting mixture using other than the method below may violate Federal, or other state and
Provincial laws.
Preparation
1.
Make sure that the following parts are in good order.
^
Ignition system
^
Engine oil and coolant levels
^
Valve clearance
2.
Connect engine tachometer and timing light in their proper positions.