350Z V6-3.5L (VQ35) (2003)
Seat Back: Service and Repair
Seatback Trim
Assembly and Disassembly
Disassembly and Assembly
SEATBACK TRIM AND PAD
1. Open fastener on back of seatback and remove retainer from seatback trim.
2. Remove the stay securing the inner cloth.
3. Squeeze and pull up headrest holder tabs to remove from seat back frame.
NOTE: Before installing the headrest holder check its orientation (front/rear and right/left).
4. Remove the seat heater harness connector. After removing the seatback trim and pad remove the hog ring to separate the trim and pad.
NOTE: Seatback heater unit is stitched into seatback trim. It cannot be separated. (For heated seat models only)
Removal and Assembly
REMOVAL OF SEATBACK ASSEMBLY
1. After completing the steps 1 of "SEATBACK TRIM AND PAD" remove the harness connectors for the reclining motor (driver seat only).
2. Pull out the harness connector for the side air bag from the seat cushion.
3. Remove the reclining device mounting bolts on the seatback frame, and remove the seatback assembly.
NOTE: When assembling the seatback frame, make sure that the reclining device are locked on both sides, and be sure to temporarily tighten the
bolts, then tighten them finally.