350Z V6-3.5L (VQ35) (2003)
Brake Pedal Assy: Service and Repair
Removal and Installation
COMPONENT PARTS DRAWING
REMOVAL
1. Remove the lower driver-side instrument panel.
2. Remove the steering column.
3. Remove the stop lamp switch and ASCD cancel switch from the pedal assembly.
4. Remove the snap pin and clevis pin from the brake booster clevis.
5. Remove the mounting nuts and bolts from the bracket, and remove the pedal assembly from the vehicle.
INSPECTION AFTER REMOVAL
^
Check that the rivets in the upper part of the brake pedal are not deformed.
^
Make sure the sub bracket and the slide plate are at least 4 mm (0.16 inch) apart.