350Z V6-3.5L (VQ35) (2003)
Electronic Brake Control Module: Service and Repair
ABS
ABS ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
Removal and Installation
Pay attention to the following when removing actuator.
CAUTION:
^
Before servicing, disconnect battery cables.
^
To remove brake tube, use flare nut wrench to prevent flare nuts and brake tube from being damaged. To install, use flare nut wrench (commercial
service tool).
^
Do not remove and install actuator by holding harness.
^
After work is completed, bleed air from brake piping.
^
Be sure to securely connect the ground cable.