350Z V6-3.5L (VQ35) (2003)
Front Tire Inspection Procedure
NOTE:
This inspection procedure is ONLY for Bridgestone 225/50R17 Potenza RE040 or Bridgestone 225/45R18 Potenza RE040 tires, original or
replacements.
1.
Make sure the pressure in all four tires is 35 P.S.I. cold.
^
It is absolutely critical (very important) that the tire pressure is set and maintained at 35 psi cold in order to "maximize" tire life.
^
If the tire pressure is below 35 P.S.I. cold, the tires may wear sooner, which can lead to increased noise.
NOTE:
Perform the following steps on both front tires ONLY. You do NOT need to perform these steps on the rear tires.
2.
Raise the vehicle on a hoist.
3.
Measure the tire in several locations as follows:
NOTE:
To do this procedure, you'll need:
^
Piece of chalk
^
Tread Check Kit J-47132 (see Figure 1). This Kit is essential to perform this procedure and was previously sent to each dealer.