350Z V6-3.5L (VQ35) (2003)
Diagnosis Sensor Unit: Service and Repair
DIAGNOSIS SENSOR UNIT
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Disconnect each harness connector for the air bag module and seat belt pre-tensioner.
2. Remove center console.
3. Disconnect diagnosis sensor unit connector.
4. Remove special bolts from the diagnosis sensor unit.
CAUTION:
-
Do not use old bolts. Replace with new ones.
-
Check diagnosis sensor unit bracket to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace
with new one.
-
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
INSTALLATION
To install reverse the removal procedure.
CAUTION:
-
Check the diagnosis sensor unit for proper installation.
-
After replacement of diagnosis sensor unit, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check". See:
Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics
ECU DISCRIMINATED NO.
After replacing the diagnosis sensor unit confirm that the diagnosis sensor unit identification is correct for the vehicle as equipped. See: Air Bag
Systems/Testing and Inspection