350Z V6-3.5L (VQ35) (2003)
1. Check the connection for damage or any foreign materials.
2. Align the connector with the tube, then insert the connector straight into the tube until a click is heard.
3. After connecting, make sure that the connection is secure by following method.
4. Pull the tube and the connector to make sure they are securely connected.
-
Visually confirm that the two retainer tabs are connected to the connector.
INSPECTION AFTER INSTALLATION
-
Use the following procedure to check for fuel leaks.
1. Turn ignition key ON (do not start engine), then check connections for leaks by applying fuel pressure to fuel piping.
2. Start the engine and let it idle and make sure there are no fuel leaks at the fuel system connections.
Disassembly and Assembly
NOTE:
-
Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.
DISASSEMBLY
Remove fuel level sensor unit with the following procedure.
1. Disconnect harness connector.
-
Hold connector by fingers and pull it out, because there is no stopper release tab.