350Z V6-3.5L (VQ35) (2003)
Impact Sensor: Service and Repair
Crash Zone Sensor
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Remove crash zone sensor connector.
2. Remove crash zone sensor fixing nuts.
CAUTION:
-
Replace crash zone sensor if it has been dropped or sustained an impact.
-
Do not attempt to disassemble crash zone sensor.
INSTALLATION
To install reverse the removal procedure.
CAUTION:
-
Check crash zone sensor for proper installation.
-
After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check" See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Diagnostic
Procedures/Air Bag System/Diagnostic Test Procedures