350Z V6-3.5L (VQ35) (2003)
/Page-1806010.png)
c. Twist boot clamp as shown in the figure, pay attention to relationship between winding and twisting directions.
d. Confirm the twisted point with clamp faces in the opposite direction to the adjusting screw within 30° as shown in the figure.
e. After twisting wire 4 to 4.5 turns, bend cut end of wire. Cut end of wire should not touch boot. Be sure wire end is at least 5 mm (0.20 inch)
away from clearance for tube.
23. Install cylinder-tube to the gear housing assembly.
24. Install lock nut and outer socket to inner socket, then tighten the lock nut temporarily until the length of tie-rod reaches to the specified value.
Tie-rod length "L": 106.3 mm (4.185 inch)
NOTE: Perform toe-in adjustment after this procedure. Length achieved after toe-in adjustment is not necessarily value given here.
