350Z V6-3.5L (VQ35) (2003)
Clutch Pedal Assembly: Service and Repair
Removal and Installation
NOTE: Tighten the ASCD cancel switch lock nut to the specified torque after installing the clutch pedal assembly in the vehicle and adjusting the
pedal height.
REMOVAL
1. Remove driver side kicking plate inner.
2. Remove foot rest.
3. Remove dash side finisher (LH).
4. Remove instrument driver panel lower.
5. Remove VDC/TCS/ABS control unit.
6. Remove the clutch inter lock switch and ASCD cancel switch connector and harness.
7. Remove the snap pin and clevis pin.
8. Remove the pedal bracket mounting bolt and nut and then remove the clutch pedal assembly.
INSPECTION AFTER REMOVAL
^
Check clutch pedal for bend, damage, or a cracked weld. If bend, damage, or a cracked weld is found, replace the clutch pedal assembly.
INSTALLATION
To install, reverse the removal procedure, following the cautions below: Install clutch pedal assembly and adjust the pedal height. Tighten ASCD
cancel switch lock nut to the specified torque.
^
After installing the clutch inter lock switch, adjust the switch position.