350Z V6-3.5L (VQ35) (2003)
CLAIMS INFORMATION
SERVICE PROCEDURE
1.
Determine if the noise is coming from one side or both sides.
^
If the noise is coming from only one side, perform procedure on only one side.
^
If the noise is coming from both sides, perform procedure on both sides.
2.
Remove the rear axle (driveshaft).
^
Refer to section RAX in the Service Manual for the driveshaft removal information.
^
IMPORTANT: Make sure to mark the driveshaft and hub as shown in Figure 1 before removing the driveshaft.