350Z V6-3.5L (VQ35) (2003)
Seals and Gaskets: Service and Repair
REAR OIL SEAL
Removal and Installation
REMOVAL
1. Remove propeller shaft.
CAUTION: Do not impact or damage propeller shaft tube.
2. Using oil seal puller (special service tool), remove oil seal.
INSTALLATION
1. Apply multi-purpose grease to oil seal lip. Using a drift (special service tool), drive in oil seal until the edge is approximately 1.7 mm (0.067 in)
above the boss edge.
CAUTION:
^
Oil seals are not reusable. Never reuse them.
^
When installing, do not incline the oil seal.
2. Install propeller shaft.
CAUTION:
^
Do not impact or damage propeller shaft tube.
^
If lubricant leak has occurred, after finishing work, check oil level.