350Z V6-3.5L (VQ35) (2003)
Windshield Washer Reservoir: All Technical Service Bulletins
Windshield Washer - Fluid Seepage
Classification:
EL02-038
Reference:
NTB02-098
Date:
September 26, 2002
WINDSHIELD WASHER FLUID SEEPAGE
APPLIED VEHICLE:
All 2003 350Z (Z33)
SERVICE INFORMATION
If an applied vehicle has windshield washer tluid seeping
^
to the ground under the right front area of the vehicle,
^
especially after refilling the washer fluid reservoir,
Determine if it is seeping from the reservoir filler neck. Refer to the Service Procedure below to isolate and resolve this incident, if it should occur.
NOTE:
^
If ALL the washer fluid has drained from the reservoir bottle, this bulletin does NOT apply.
^
The amount ot fluid that could seep out due to this incident, if it occurs, is only the amount in the filler neck.
SERVICE PROCEDURE
1.
Remove the right front wheel/tire assembly.
2.
Remove the right front inner fender protector. Refer to page EI-21 of the 2003 350Z Electronic Service Manual for fender protector removal
information.
3.
Using moderate force, push the black plastic filler tube down into the white plastic reservoir. Push until there is no gap between the shoulder of the
filler neck and the reservoir neck top.