370Z V6-3.7L (VQ37VHR) (2010)
Technical Service Bulletin # 10-033A
Date: 101201
Navigation Radio - Configuration After Replacement
Classification: EL10-008A
Reference: NTB10-033A
Date: December 1, 2010
AV CONTROL UNIT REPLACEMENT REQUIRES CONSULT-III CONFIGURATION
APPLIED VEHICLES:
2010-2011 370Z Coupe and Roadster (H/Z34)
2010-2011 Altima Coupe, Sedan, and Hybrid (C/L32/HV)
2010-2011 Maxima (A35)
2011 GT-R (R35)
2011 Murano (Z51)
SERVICE INFORMATION
If the AV Control Unit needs to be replaced on an Applied Vehicle for any reason, follow the steps in the Service Procedure to configure the Multi AV
system.
NOTE:
The original AV Control Unit must be installed in the vehicle while performing part of this procedure. DO NOT remove the original AV Control Unit
until instructed.
SERVICE PROCEDURE
Before starting, make sure your AS 1ST has been freshly synchronized and all CONSULT-III upgrades have been installed.
Parts of the Procedure
Procedures 1, 2, 3, 4, and 5
PART 1: Read Multi AV Configuration of the Original AV Control Unit and Write Down Configuration Values; Replace the AV Control Unit
1. Make sure the shift selector is in Park.
2. Connect the C-III VI to the vehicle.
3. Turn ON the ignition.
NOTE:
You may want to start the engine to keep the battery charged during this procedure.
4. Open/start ASIST on the C-III computer, then select CONSULT Utilities> CONSULT III.
5. Perform the usual C-III start-up selections:
a. Wait for the "Detecting VI/MI in progress" message to clear.