Nissan and Datsun Workshop Service and Repair Manuals

Rear Subframe: Procedures

REAR SUSPENSION MEMBER

Inspection

INSPECTION AFTER REMOVAL
Check rear suspension member for deformation, cracks, or any other damage. Replace if necessary.

INSPECTION AFTER INSTALLATION
1. Adjust parking brake operation (stroke).  See: Brakes and Traction Control/Parking Brake System/Testing and Inspection/Component Tests and

General Diagnostics/Inspection And Adjustment.

2. Check wheel alignment.  See: Alignment/Service and Repair/Wheel Alignment Inspection.
3. Adjust neutral position of steering angle sensor.  See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and

Inspection/Programming and Relearning/Additional Service When Replacing Control Unit/Description See: Brakes and Traction Control/Antilock
Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning/Additional Service When Replacing Control Unit/Special
Repair Requirement See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and
Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Description See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Testing and Inspection/Programming and Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Special Repair
Requirement