370Z V6-3.7L (VQ37VHR) (2010)
![background image](/nissan/370z/v6-3.7l_(vq37vhr)/Page-885002.png)
-
Clean the matching surface of drive shaft and wheel hub and bearing assembly. And then apply paste [service parts (440037S000)]
to surface (A) of joint sub-assembly of drive shaft.
CAUTION:
Apply paste to cover entire flat surface of joint sub-assembly of drive shaft.
Amount paste : 1.0 - 3.0 g (0.04 - 0.10 oz)
-
Use the following torque range for tightening the wheel hub lock nut.
Torque: 180 N.m (18.4 kg-m, 133 ft-lb) - 185 N.m (18.8 kg-m, 136 ft-lb)
CAUTION:
-
Since the drive shaft is assembled by press-fitting, use the tightening torque range for the wheel hub lock nut.
-
Be sure to use torque wrench to tighten the wheel hub lock nut. Never use a power tool.
NOTE:
Wheel hub lock nut tightening torque does not over torque for avoiding axle noise, and does not less than torque for avoiding looseness.
-
Never use a power tool to tighten the wheel hub lock nut.
-
Perform the final tightening of each of parts under unladen conditions, which were removed when removing wheel hub and bearing assembly and
axle housing.
-
Never reuse cotter pin and wheel hub lock nut.