810 Maxima L6-2793cc 2.8L DSL SOHC (LD28) (1982)
NOTES:
a) Remove inner cable from outer case, then grind off approximately 2mm from the end of the cable that is connected to the speedometer.
Make certain all sharp edges are removed.
b)
Remove inner cable from outer case, then remove any sharp edges from end of the inner cable that is connected to the speedometer.
c)
Readjust cable or tie-wraps so that any sharp cable bends are eliminated. Refer to Appendix for the proper cable routing for each
model.
d)
If the foreign particles are rust, metal chips, etc., clean with compressed air; if the contamination is grease, replace the speedometer and
speedometer cable; if the contamination is oil, replace the speedometer, speedometer cable and/or pinion gear.
Warrany Information
Inspection
Operation
CS*
PNC
CT
Item **
Number
Flat Rate
4R or 4S
24850
A
.2 Hr.
4R or 4S
25050
32
B (1)
BE 1030
4R or 4S
25050
01
B (2)
BE 1030
4R or 4S
25050
01
B (3)
BE 1030
Use time for opera-
4R or 4S
25050
35
B (4)
BE 1030
tion BE 1030 + .2 Hr.
4R or 4S
25050
01
B (5)
BE 1030
4R or 4S
25050
02
B (6)
BE 1030
4R or 4S
32703 M/T
TM 1020 M/T
.3 Hr.
31703 A/T
03
C (1)
AT 0200 A/T
4R or 4S
24850
33
D (1)
BE 1010
Use time for opera-
tion BE 1010
*4R = Speedo. noise
4S = Pointer vibration
**Letters refer to boxes in Troubleshooting Chart, page 3, and numbers in parentheses refer to Inspection and Correction Procedures chart, page 4.
Appendix