Altima L4-2.5L (QR25DE) (2009)
14. Version 1 only: Install the temp sensors wiring into the retention feature as shown in Figure 12.
^
Route the temp sensor's wires to the right of the level sensor.
^
Make sure the wiring is clear of float arm movement.
^
Make sure the wiring is within 0.5 inches (13 mm) from the side of the module.
15. Version 2 only: Secure the level sensors wires into the retention features (see Figure 13).
^
Make sure the wiring is within 0.5 inches (13 mm) from the side of the module.