Altima 2.5 SL L4-2.5L (QR25DE) (2002)
^
Re-torque all fasteners to specification (see Figure D3).
CAUTION:
When tightening the rear suspension member mounting nuts, DO NOT EXCEED 100 N-m (10.3 Kg-m, 74 ft-lb).
^
Use a "backup" wrench when tightening fasteners that use a nut and a bolt.
^
Re-connect the ABS wire harnesses (if equipped) making sure they are snapped" in place.
^
Use a new gasket between the catalytic converter and center exhaust tube.
^
Connect and adjust the parking brake cables.
^
When re-installing the rear rotors to the hubs, make sure the mating surfaces are clean. If necessary, use a wire brush to remove any rust or
debris. This will help prevent rotor run-out / brake judder. Also, make sure you correctly index" the rotor to the hub.
5.
Perform a rear wheel alignment.