Altima 2.5 SL L4-2.5L (QR25DE) (2002)
SERVICE PROCEDURE
NOTE:
Use suitable covers to protect upholstery, carpeting, etc. when performing this Procedure.
Preliminary Steps
NOTE:
^
Steps 1, 2 and 3 below, only apply to vehicles equipped with Front Side (SRS) Air Bags.
^
These vehicles equipped with Front Side (SRS) Air Bags have a tag on the front seatback (see Figure 1).
1.
Write down all radio station presets.
2.
Disconnect both battery cables, negative cable first.
3.
Wait at least 3 minutes after the negative battery cable is disconnected before proceeding with step 4 below.
Tilt Seat and Add Spacer Washer
4.
Remove the four bolts that secure the driver's seat to the floor.
^
Refer to section SE in the Service Manual (ESM) for seat removal information.
5.
Carefully tilt the seat back to reach the bottom of the seat (see Figure 2).
^
If needed, disconnect electrical connectors so you can tilt the seat.
6.
Install the new Spacer Washer as shown in Figure 2.
^
Make sure the new Spacer Washer is fully inserted and locked into position.