Altima 2.5 SL L4-2.5L (QR25DE) (2002)
PARTS INFORMATION
CLAIMS INFORMATION
Submit a "Campaign" (CM) line claim using the claims coding information shown.
Information
Install the Connector Clips (supplied in Kit P/N: 24345-6N025) onto the Driver's SRS Air Bag Module Harness Connectors as follows: (Altima and
Xterra)
NOTE:
Use suitable covers to protect upholstery carpeting. etc performing the Service Procedure.
Altima
Preliminary Steps:
1.
Write down all radio station presets.
2.
Remove any accessory (phone chapter 12V Power Outlet(s)
WARNING:
^
Do NOT use a Computer Memory (9-volt power source), that into the 12V Power Outlet(s), to retain memory settings on the computer and radio
^
No voltage should be present in the system when performing this procedure
3.
Disconnect both battery cables
4.
Wait 3 minutes before proceeding with the following steps.
Reposition Driver's SRS Air Bag Module
5.
Using a screwdriver, carefully removing left and right plastic screw. This will allow you to reach the Air Bag Module Mounting Screws (see
Figure 1).