Altima 2.5 SL L4-2.5L (QR25DE) (2002)
![background image](/nissan/altima_2.5_sl/l4-2.5l_(qr25de)/Page-2316001.png)
Impact Sensor: Service and Repair
Crash Zone Sensor
Removal and Installation
REMOVAL
CAUTION: Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Remove front grille.
2. Remove crash zone sensor connector.
3. Remove crash zone sensor fixing nuts.
CAUTION:
-
Replace crash zone sensor if it has been dropped or sustained an impact.
-
Do not attempt to disassemble crash zone sensor.
INSTALLATION
To install, reverse the removal procedure.
CAUTION:
-
Check crash zone sensor for proper installation.
-
After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check".