Altima 2.5 SL L4-2.5L (QR25DE) (2002)
12.
Remove the four main suspension member mounting nuts and the LH/RH stay brackets (see Figure A18).
^
For all 2002 Altimas and 2003 Altimas built up to 1/24/03: Do NOT re-use the original stay brackets. Install new ones. See the Parts
Information section.
CAUTION:
Do not damage the studs/threads when removing the four main suspension member mounting nuts. Take note of the following when removing
these nuts.
To avoid breaking stud(s) / damaging threads:
^
Before removing, clean the exposed threads with a wire brush or other suitable tool and apply Genuine Nissan Rust Penetrant P/N
999MP-A3020P (or equivalent).
^
Use plenty of penetrant and slowly work the nut counter-clockwise and clockwise as the nut progresses down the threads of the stud (like
working with a tap or die).
CAUTION:
When removing the rear suspension member mounting nuts DO NOT use any breaker bar or ratchet handle extensions, such as a long pipe, to
loosen the nuts.
^
If the suspension member mounting nuts cannot be loosened do steps A through D below.
For this procedure, you'll need 1) A die grinder with a small diameter, burr-type cutting attachment 2) A small cold chisel 3) A ball peen hammer.
NOTE: