Altima 2.5 SL L4-2.5L (QR25DE) (2002)
Clutch Slave Cylinder: Service and Repair
Removal and Installation
OPERATING CYLINDER
REMOVAL
1. Drain brake fluid from hydraulic clutch system.
CAUTION: Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it
away with water immediately.
2. Remove union bolt and clutch hose from operating cylinder.
3. Remove operating cylinder mounting bolts, and remove cylinder from vehicle.
INSTALLATION
Installation is in the reverse order of removal. Follow the operations described below.
CAUTION: Install the hose without twisting it.
^
The copper washer of the union bolt should not be reused. Always use a new copper washer for installation.
^
After finishing the operation, bleed air from the clutch piping.
See: Clutch Fluid