Altima SE L4-2.4L (KA24DE) (1997)
4.
Install foam seals C and D to the underside of the passenger side cowl top panel as follows (see Figure 2):.
A.
Clean the surface of the cowl top panel where the foam seals will be installed.
B.
Using spray adhesive (3M® brand Super 77 P/N 021200-21210 or equivalent) install foam seal D to the underside of the cowl top panel
(see Figure 2).
C.
Remove the self adhesive cover strip and install foam seal C to the underside of the cowl top panel (see Figure 2).
5.
Remove debris in the cowl and HVAC intake areas.
6.
Remove the HVAC blower motor assembly and remove debris inside the blower motor assembly.
7.
Remove debris from within the inlet side of the A/C evaporator assembly. Do not remove the NC evaporator assembly.
NOTE:
The best way to remove debris is to use a wet/dry vacuum cleaner
8.
Reinstall the blower motor assembly.
9.
Reinstall the cowl top panel.
10.
Reinstall the windshield wiper arms and the attachment nuts.
IMPORTANT:
Use the procedure on page EL-106 of the 1996 Altima Service Manual to properly install the windshield wiper arms.
PARTS INFORMATION
CLAIMS INFORMATION
When applicable, standard claims coding applies.