Altima XE L4-2.4L (KA24DE) (1999)
Steering Gear: Service and Repair
Removal and Installation
REMOVAL AND INSTALLATION
CAUTION: The rotation of the spiral cable (SRS "AIR BAG" component part) is limited. If the steering gear must be removed, set the front wheels
in the straight-ahead direction. Do not rotate the steering column while the steering gear is removed.
-
Loosen upper clamp on dust boot in engine compartment.
-
Remove lower bolt from coupling joint.
-
Detach tie-rod outer sockets from knuckle arms with tool.
-
After removing steering gear from vehicle, mark pinion shaft and pinion housing to record neutral position.
-
To install, set left and right dust boots to equal deflection, and align matching marks on pinion shaft and pinion housing.