Armada 2WD V8-5.6L (VK56DE) (2006)
Seat Belt Retractor: Service and Repair
Front
FRONT SEAT BELT RETRACTOR
Removal
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
2. Remove the center pillar upper/lower finishers. Refer to "BODY SIDE TRIM".
3. Remove the seat belt retractor anchor bolts and seat belt retractor and belt assembly.
-
On RH side, disconnect the seat belt tension sensor.
4. Disconnect the seat belt pre-tensioner electrical connector.
CAUTION:
-
For removing pre-tensioner connector, insert a thin screwdriver (1) wrapped in tape (3) into the notch. Lift the locking tab to unlock (2), then
remove the connector.
-
Install the pre-tensioner connector with the locking tab raised, then push the locking tab into the connector to lock (4).
Installation
Installation is in the reverse order of removal.