Armada 4WD V8-5.6L (VK56DE) Flex Fuel (2009)
2. Check output rod length.
Output rod length : Refer to See: Specifications
INSTALLATION
1. Loosen lock nut to adjust input rod length so that the length (B) is set at the specified value.
Input rod length (B) : Refer to See: Specifications
2. After adjusting length (B), temporarily tighten lock nut and install brake booster.
-
Install the gaskets and spacer block between brake booster and dash panel.
3. Connect brake pedal to clevis on the input rod.
4. Install brake booster to brake pedal assembly nuts and tighten to the specified torque.
5. Install brake piping to the master cylinder assembly. Refer to See: Hydraulic System/Diagrams.
6. Connect active boost and delta stroke sensor harness connectors to brake booster.
7. Connect vacuum hose to brake booster.
8. Install master cylinder assembly to brake booster. Refer to See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and
Replacement.
9. Adjust the height and play of brake pedal. Refer to See: Brake Pedal Assy/Testing and Inspection.
10. Tighten lock nut of input rod to specification.
11. Install engine air duct assembly. Refer to See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Removal and Installation.
12. Install engine room cover. Refer to See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Cover.
13. Refill with new brake fluid and bleed air. Refer to See: Brake Bleeding/Service and Repair.
Removal And Installation
VACUUM LINES
Removal and Installation