Axxess 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
Throttle Position Sensor: Adjustments
Idle Switch
1.
Start and warm the engine to operating temperature.
2.
Disconnect the idle switch connector.
3.
Connect an ohm meter or continuity tester between terminals B and C.
4.
Connect a tachometer to the engine.
5.
Raise the engine rpm to 2000 rpm and slowly lower to idle.
6.
Confirm that continuity does not exist until engine rpm reaches 1000 +/- 150.
7.
If not within specified range, loosen the two securing screws and rotate switch until within range.
8.
Tighten screws and recheck.