Cube L4-1.8L (MR18DE) (2010)
Rear Vision Camera: Adjustments
REAR VIEW CAMERA
Adjustment
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1. Draw lines on rearward area of the vehicle passing through the following points: 200 mm (7.87 in) from both sides of the vehicle, and 0.5 m (1.64
ft), 1.0 m (3.28 ft) from the rear end of the bumper.
2. Set into "Camera system" mode of Confirmation / Adjustment mode.
3. Press "1" or "2" switches, and then select the guiding line pattern so that its angle is aligned with the correction line of the rear of the vehicle.
Selected pattern : 7
4. Make fine adjustment to the correction line of the rear of the vehicle with "3", "4", "5" or "6" switches so that its position is aligned with the
guiding line. Press "PUSH ENTER" switch and record the adjusted guiding line position to the camera control unit.
CAUTION:
Never operate other function such as pressing BACK while writing index data.