Cube L4-1.8L (MR18DE) (2010)
Hood Latch: Service and Repair
Removal And Installation
With Intelligent Key System
HOOD LOCK
Removal and Installation
REMOVAL
1. Remove front grille. See: Grille/Service and Repair/Front Grille (Regular Grade)/Removal And Installation.
2. Remove mounting bolts, and then remove hood lock assembly.
3. Disconnect hood lock cable from hood lock assembly.
4. Remove hood lock cable clip.
5. Remove fender protector (LH). See: Fender/Front Fender/Front Fender Liner/Service and Repair/Removal And Installation.
6. Remove hood lock opener lever.
7. Disconnect hood lock cable from hood lock opener lever.
8. Remove grommet on the lower dash, and pull the hood lock control cable toward the passenger compartment.
CAUTION:
While pulling, never to damage (peeling) the outside of hood lock control cable.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Never to bend cable too much, keeping the radius 100 mm (3.937 in) or more.
-
Check that cable is not offset from the positioning grommet, and apply the sealant to the grommet (at * mark) properly.
-
Check that hood lock control cable is properly engaged with hood lock.
-
After installation, perform hood fitting adjustment. See: Adjustments/With Intelligent Key System.
-
After installation, perform hood lock control inspection. See: Inspection/With Intelligent Key System.
Without Intelligent Key System
HOOD LOCK
Removal and Installation
REMOVAL
1. Remove front grille. See: Grille/Service and Repair/Front Grille (Regular Grade)/Removal And Installation.
2. Remove mounting bolts, and then remove hood lock assembly.
3. Disconnect hood lock cable from hood lock assembly.
4. Remove hood lock cable clip.
5. Remove fender protector (LH). See: Fender/Front Fender/Front Fender Liner/Service and Repair/Removal And Installation.
6. Remove hood lock opener lever.
7. Disconnect hood lock cable from hood lock opener lever.
8. Remove grommet on the lower dash, and pull the hood lock control cable toward the passenger compartment.
CAUTION:
While pulling, never to damage (peeling) the outside of hood lock control cable.
INSTALLATION