Cube L4-1.8L (MR18DE) (2010)
Trunk / Liftgate Handle: Service and Repair
Removal And Installation
With Intelligent Key System
BACK DOOR LOCK
OUTSIDE HANDLE : Removal and Installation
REMOVAL
1. Remove back door finisher lower. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Removal And Installation.
2. Remove sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
3. Disconnect back door antenna and back door request switch connector and remove harness clamp (with intelligent key system) on outside handle
bracket.
4. Remove mounting bolt of outside handle bracket.
5. While pulling outside handle, remove outside handle escutcheon.
6. While pulling outside handle (1), slide toward rear of vehicle to remove outside handle.
7. Remove front gasket and rear gasket.
8. While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket.
9. Reach in to separate outside handle cable connection on outside handle bracket.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Check back door open/close operation after installation.
-
Check door lock cable is properly engaged with outside handle bracket.
Without Intelligent Key System
BACK DOOR LOCK
OUTSIDE HANDLE : Removal and Installation
REMOVAL
1. Remove back door finisher lower. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Removal And Installation.
2. Remove sealing screen.