Cube L4-1.8L (MR18DE) (2010)
Trunk / Liftgate Stop: Service and Repair
Removal And Installation
With Intelligent Key System
BACK DOOR
DOOR CHECK LINK : Removal and Installation
REMOVAL
1. Remove back door finisher lower. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Removal And Installation.
2. Remove sealing screen.
NOTE:
Cut the butyl-tape so that some part of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
3. Remove mounting bolts of door check link on the vehicle.
4. Remove mounting nuts of door check link on the back door panel.
5. Take door check link out from the hole of back door panel.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check back door open/close operation after installation.
Without Intelligent Key System
BACK DOOR
DOOR CHECK LINK : Removal and Installation
REMOVAL
1. Remove back door finisher lower. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Removal And Installation.
2. Remove sealing screen.
NOTE:
Cut the butyl-tape so that some part of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
3. Remove mounting bolts of door check link on the vehicle.
4. Remove mounting nuts of door check link on the back door panel.
5. Take door check link out from the hole of back door panel.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check back door open/close operation after installation.