Cube L4-1.8L (MR18DE) (2010)
Cowl Moulding / Trim: Service and Repair
Removal And Installation
COWL TOP
Removal and Installation
REMOVAL
1. Fully open hood assembly.
2. Remove front wiper arm, and blades (LH/RH). See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Front Wiper Arm/Removal And
Installation.
3. Remove front fender cover. See: Fender/Front Fender/Service and Repair/Removal and Installation/With Intelligent Key System.
4. Remove cowl top cover fixing clips.
5. Pull forward to release cowl top cover from windshield glass.
CAUTION:
When performing the procedure after removing cowl top cover, cover the lower and of windshield glass with urethane etc.
6. Disconnect wind washer tube connector.
7. Remove cowl top cover.
8. Remove the following parts after removing cowl top cover.
-
EPT sealer
-
Cowl top cover seal
-
Washer tube
-
Washer nozzles. See: Wiper and Washer Systems/Windshield Washer Spray Nozzle/Service and Repair/Front Washer Nozzle And Tube/Removal
And Installation.
9. Remove front wiper drive assembly. See: Wiper and Washer Systems/Wiper Motor Linkage/Service and Repair/Removal And Installation.
10. Remove cowl top extension mounting bolts, and them cowl top extension.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Always replace cowl top cover EPT sealer on rear of vehicle with a new one when installing old cowl top cover.
-
After installing, perform adjustment of wiper arm. See: Wiper and Washer Systems/Wiper Arm/Adjustments/Front Wiper Arm.