Cube L4-1.8L (MR18DE) (2010)
Headliner: Service and Repair
Removal And Installation
HEADLINING
Removal and Installation
REMOVAL
1. Remove front body side welt (LH/RH) and rear body side welt (LH/RH). See: Trim Panel/Service and Repair/Removal And Installation.
2. Remove front pillar garnish (LH/RH). See: Trim Panel/Service and Repair/Removal And Installation.
3. Disconnect microphone harness connector (A).
4. Remove center pillar upper garnish (LH/RH). See: Trim Panel/Service and Repair/Removal And Installation.
5. Remove luggage side upper finisher (LH/RH). See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and
Repair/Luggage Floor Trim/Removal And Installation.
6. Remove sunvisor assembly mounting screws, and then remove sunvisor assembly (LH/RH).
7. Remove inside mirror cover and then remove inside mirror. See: Mirrors/Service and Repair/Inside Mirror/Removal And Installation.
8. Disengage room lamp lens fixing pawls with a remover tool, the mounting screws and then remove the room lamp. See: Lighting and Horns/Dome
Lamp/Service and Repair/Removal And Installation.
Broken Triangle : Pawl
9. Disengage the map lamp fixing pawls with a remover tool and then remove the map lamp.
Broken Triangle : Pawl
10. Remove the assist grips.
-
Insert a small minus driver as shown by the arrow in the figure to disengage the fixing pawls.
-
Remove the mounting bolts.
-
Pull out the assist grip to remove.