Cube L4-1.8L (MR18DE) (2010)
With Intelligent Key System
REAR DOOR LOCK
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove rear door finisher. See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Removal And Installation.
2. Remove sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
3. Remove rear door glass. See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door Window Glass/Service and Repair/Removal And Installation.
4. Remove outside handle. See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door Handle/Rear Door Exterior Handle/Service and
Repair/Removal and Installation/With Intelligent Key System.
5. Remove inside handle. See: Doors, Hood and Trunk/Doors/Rear Door/Rear Door Handle/Rear Door Interior Handle/Service and Repair/Removal
and Installation/With Intelligent Key System.
6. Remove door lock assembly TORX bolts.
7. Disconnect door lock actuator connector, and then remove door lock assembly.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Check door open/close, lock/unlock operation after installation.
-
Check door lock cable is properly engaged with outside handle bracket.
Without Intelligent Key System
REAR DOOR LOCK
DOOR LOCK : Removal and Installation