nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5316 > < Initial Inspection and Diagnostic Overview|Page 5314
Page 37
background image

Is the inspection result normal?
YES  - Replace BCM.  See: Body Control Systems/Body Control Module/Service and Repair/With Intelligent Key System/Removal And Installation.
NO - Repair or replace harness.

With Intelligent Key System

DOOR LOCK ACTUATOR

REAR LH : Component Function Check

1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test ("DOOR LOCK").
2. Touch "ALL LOCK" or "ALL UNLK" to check that it works normally.
Is the inspection result normal?
YES  - Door lock actuator is OK.
NO -  See: Component Tests and General Diagnostics/Door Lock Actuator/Rear RH/Diagnosis Procedure/With Intelligent Key System.

Without Intelligent Key System

DOOR LOCK ACTUATOR

REAR LH : Component Function Check

1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test ("DOOR LOCK").
2. Touch "ALL LOCK" or "ALL UNLK" to check that it works normally.
Is the inspection result normal?
YES  - Door lock actuator is OK.
NO -  See: Component Tests and General Diagnostics/Door Lock Actuator/Rear RH/Diagnosis Procedure/Without Intelligent Key System.

With Intelligent Key System

DOOR LOCK ACTUATOR

REAR LH : Description

Locks/unlocks the door with the signal from BCM.

DOOR LOCK ACTUATOR

REAR LH : Diagnosis Procedure

1.CHECK DOOR LOCK ACTUATOR INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect rear door lock assembly LH connector.
3. Check voltage between rear door lock assembly LH harness connector and ground.

Is the inspection result normal?
YES  - Replace rear door lock assembly LH.  See: Door Locks/Service and Repair/Rear Door Lock/Removal And Installation/With Intelligent Key
System.
NO - GO TO 2.
2.CHECK DOOR LOCK ACTUATOR CIRCUIT

Initial Inspection and Diagnostic Overview|Page 5316 > < Initial Inspection and Diagnostic Overview|Page 5314