Cube L4-1.8L (MR18DE) (2010)
- Front combination lamp: See: Lighting and Horns/Headlamp/Adjustments/Aiming Adjustment Procedure.
Without Intelligent Key System
RADIATOR CORE SUPPORT
Removal and Installation
RADIATOR CORE SUPPORT UPPER
REMOVAL
1. Remove front bumper fascia and bumper reinforcement. See: Bumper/Front Bumper/Service and Repair/Removal And Installation.
2. Remove hood lock. See: Doors, Hood and Trunk/Hood/Hood Latch/Service and Repair/Removal And Installation/Without Intelligent Key System
.
3. Remove front combination lamps (LH/RH). See: Lighting and Horns/Headlamp/Service and Repair/Removal And Installation.
4. Remove air guide.
5. Remove horn. See: Lighting and Horns/Horn/Service and Repair/Removal And Installation.
6. Remove crash zone sensor. See: Restraint Systems/Air Bag Systems/Impact Sensor/Service and Repair/Crash Zone Sensor/Removal And
Installation.
7. Remove ambient sensor. See: Heating and Air Conditioning/Ambient Temperature Sensor / Switch HVAC/Service and Repair/Removal And
Installation.
8. Disconnect all harness from radiator core support upper.
9. Remove air duct assembly. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair/Removal And Installation.
10. Remove radiator core support upper bracket (LH/RH).
11. Remove mounting bolts, and then remove radiator core support upper.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
After installation, adjust the following parts.
- Front combination lamp: See: Lighting and Horns/Headlamp/Adjustments/Aiming Adjustment Procedure.
RADIATOR CORE SUPPORT LOWER
REMOVAL
1. Remove front bumper fascia and bumper reinforcement. See: Bumper/Front Bumper/Service and Repair/Removal And Installation.
2. Remove air guide.
3. Remove radiator core lower stay.
4. Remove clips of fender protector.
5. Remove floor under cover. See: Interior Moulding / Trim/Service and Repair/Removal And Installation.
6. Use a belts (A) to suspend it to prevent it from falling.
CAUTION:
Never damage radiator and condenser.
7. Remove mounting bolts, and then remove radiator core support lower.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
After installation, adjust the following parts.
- Front combination lamp: See: Lighting and Horns/Headlamp/Adjustments/Aiming Adjustment Procedure.