Cube L4-1.8L (MR18DE) (2010)
Seats: Service Precautions
Precaution For Work
PRECAUTIONS
Precaution for Work
-
When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to
protect it with a shop cloth.
-
When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a shop cloth or vinyl tape to
protect it.
-
Protect the removed parts with a shop cloth and keep them.
-
Replace a deformed or damaged clip.
-
If a part is specified as a non-reusable part, always replace it with new one.
-
Be sure to tighten bolts and nuts securely to the specified torque.
-
After re-installation is completed, be sure to check that each part works normally.
-
Follow the steps below to clean components.
- Water soluble foul: Dip a soft cloth into lukewarm water, and wring the water out of the cloth to wipe the fouled area.
Then rub with a soft and dry cloth.
- Oily foul: Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%), and wipe the fouled area.
Then dip a cloth into fresh water, and wring the water out of the cloth to wipe the detergent off. Then rub with a soft and dry cloth.
-
Never use organic solvent such as thinner, benzene, alcohol, and gasoline.
-
For genuine leather seats, use a genuine leather seat cleaner.