Cube L4-1.8L (MR18DE) (2010)
Wheel Speed Sensor: Service and Repair
Rear Wheel Sensor
Exploded View
WHEEL SENSOR
REAR WHEEL SENSOR : Exploded View
Removal And Installation
WHEEL SENSOR
REAR WHEEL SENSOR : Removal and Installation
REMOVAL
1. Remove wheel sensor from wheel hub and bearing assembly.
CAUTION:
Never twist sensor harness as much as possible, when removing it. Pull wheel sensors out without pulling sensor harness.
2. Remove wheel sensor harness from vehicle.
CAUTION:
Never twist sensor harness as much as possible, when removing it. Pull wheel sensors out without pulling sensor harness.
INSTALLATION
Note the following, and install in the reverse order of the removal.
-
Make sure there is no foreign material such as iron chips on and in the mounting hole of the wheel sensor.
-
Make sure no foreign material has been caught in the sensor rotor. Remove any foreign material and clean the mount. Replace the wheel sensor if
necessary.
-
When installing wheel sensor, be sure to press rubber grommets in until they lock at locations shown above in the figure. When installed, harness
must not be twisted.