Cube L4-1.8L (MR18DE) (2010)
Yaw Rate Sensor: Service and Repair
Removal And Installation
YAW RATE/SIDE G SENSOR
Removal and Installation
REMOVAL
CAUTION:
-
Never drop or strike yaw rate/side G sensor, or never use power tool etc., because yaw rate/side G sensor is sensitive to the impact.
1. Remove front (left side) seat. See: Body and Frame/Seats/Service and Repair/Front Seat/Exploded View.
2. Remove dash side finisher and front kicking plate inner. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Exploded
View.
3. Remove floor trim. See: Body and Frame/Interior Moulding / Trim/Carpet/Service and Repair/Exploded View.
4. Disconnect yaw rate/side G sensor harness connector.
5. Remove yaw rate/side G sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
Never drop or strike yaw rate/side G sensor, or never use power tool etc., because yaw rate/side G sensor is sensitive to the impact.