Cube L4-1.8L (MR18DE) (2010)
NO - Repair open circuit or short to ground or short to power in harness or connectors.
8.CHECK ASCD BRAKE SWITCH
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/ASCD Brake
Switch/Component Inspection (ASCD Brake Switch).
Is the inspection result normal?
YES - GO TO 9.
NO - Replace ASCD brake switch.
9.CHECK INTERMITTENT INCIDENT
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Service Information For Electrical Incident/Intermittent Incident.
- INSPECTION END
Component Inspection (ASCD Brake Switch)
ASCD BRAKE SWITCH
Component Inspection (ASCD Brake Switch)
1.CHECK ASCD BRAKE SWITCH-I
1. Turn ignition switch OFF.
2. Disconnect ASCD brake switch harness connector.
3. Check the continuity between ASCD brake switch terminals under the following conditions.
Is the inspection result normal?
YES - INSPECTION END
NO - GO TO 2.
2.CHECK ASCD BRAKE SWITCH-II
1. Adjust ASCD brake switch installation. See: Brakes and Traction Control/Brake Pedal Assy/Adjustments.
2. Check the continuity between ASCD brake switch terminals under the following conditions.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace ASCD brake switch.
Component Inspection (ASCD Clutch Switch)
ASCD BRAKE SWITCH
Component Inspection (ASCD Clutch Switch)
1.CHECK ASCD CLUTCH SWITCH-I
1. Turn ignition switch OFF.
2. Disconnect ASCD clutch switch harness connector.
3. Check the continuity between ASCD clutch switch terminals under the following conditions.
Is the inspection result normal?
YES - INSPECTION END
NO - GO TO 2.
2.CHECK ASCD CLUTCH SWITCH-II