Cube L4-1.8L (MR18DE) (2010)
-
Remove main bearing cap and bearings, and using the scale (A) on the plastigage bag, measure the plastigage width.
NOTE:
The procedure when the measured value exceeds the limit is same as that described in the "Method by Calculation".
MAIN BEARING CRUSH HEIGHT
-
When main bearing cap is removed after being tightened to the specified torque with main bearings (1) installed, the tip end of bearing must
protrude (B). See: Service and Repair/Disassembly And Assembly.
-
If the standard is not met, replace main bearings.
CONNECTING ROD BEARING CRUSH HEIGHT
-
When connecting rod cap is removed after being tightened to the specified torque with connecting rod bearings (1) installed, the tip end of bearing
must protrude (B). See: Service and Repair/Disassembly And Assembly.
-
If the standard is not met, replace connecting rod bearings.
MAIN BEARING CAP BOLT OUTER DIAMETER