Cube L4-1.8L (MR18DE) (2010)
Drive Belt: Removal and Replacement
Removal And Installation
DRIVE BELT
Removal and Installation
REMOVAL
1. Remove front wheel and tire (RH).
2. Remove front fender protector (RH). See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Exploded View.
3. Hold the hexagonal part (A) of drive belt auto-tensioner (1) with a wrench securely. Then move the wrench handle in the direction of arrow
(loosening direction of tensioner).
CAUTION:
Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
4. Insert a rod approximately 6 mm (0.24 in) in diameter such as short-length screwdriver into the hole (B) of the retaining boss to fix drive belt
auto-tensioner.
-
Keep drive belt auto-tensioner pulley arm locked after drive belt is removed.
5. Remove drive belt.
INSTALLATION
1. Install drive belt.
CAUTION:
-
Confirm drive belt is completely set to pulleys.
-
Check for engine oil, working fluid and engine coolant are not adhered to drive belt and each pulley groove.
2. Release drive belt auto-tensioner, and apply tension to drive belt.
3. Turn crankshaft pulley clockwise several times to equalize tension between each pulley.
4. Confirm tension of drive belt at indicator (notch on fixed side) is within the possible use range. See: Exploded View.
Exploded View
DRIVE BELT
Exploded View