Cube L4-1.8L (MR18DE) (2010)
Idler Pulley: Service and Repair
Removal And Installation
DRIVE BELT AUTO TENSIONER AND IDLER PULLEY
Removal and Installation
Removal
1. Remove the following parts.
-
Engine cover: See: Access Cover/Service and Repair/Exploded View.
-
Cowl top cover and extension cowl top: See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Exploded View.
-
Vacuum lines: See: Brakes and Traction Control/Power Brake Assist/Vacuum Brake Booster/Service and Repair/Removal and
Replacement/Vacuum Lines/Exploded View.
-
Air duct: See: Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair/Exploded View.
-
Front fender protector (RH): See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Exploded View.
-
Ground cable (between front cover and radiator core support)
2. Remove drive belt. See: Drive Belt/Service and Repair/Removal and Replacement/Removal And Installation.
-
Keep drive belt auto-tensioner pulley arm locked after drive belt are removed.
3. Support the bottom surface of engine using a transmission jack, and then remove the engine mounting bracket (RH) and the engine mounting
insulator (RH). See: Service and Repair/Removal and Replacement/Exploded View.
CAUTION:
Never damage or scratch oil pan (lower) when supporting.
4. Loosen mounting bolt and remove drive belt auto-tensioner.
-
Lift the front side of the engine with a jack sustaining engine base to remove mounting bolt.
Installation
Install in the reverse order of removal.
CAUTION:
When installing drive belt auto-tensioner, be careful not to interfere with water pump pulley.