Cube L4-1.8L (MR18DE) (2010)
Arrow Indicates : Engine front
b. Insert seal cutter [SST: KV10111100 (J-37228)] (A) between oil pan (upper) and oil pan (lower).
CAUTION:
-
Be careful not to damage the mating surface.
-
Never insert a screwdriver. This damages the mating surfaces.
c. Slide the seal cutter [SST: KV10111100 (J-37228)] by tapping on the side of tool with a hammer.
d. Remove oil pan (lower).
INSTALLATION
1. Install oil pan (lower) as follows:
a. Use a scraper (A) to remove old liquid gasket from mating surfaces.
-
Also remove old liquid gasket from mating surface of oil pan (upper).
-
Remove old liquid gasket from the bolt holes and threads.
CAUTION:
Never scratch or damage the mating surface when cleaning off old liquid gasket.