Cube L4-1.8L (MR18DE) (2010)
Solar Sensor: Testing and Inspection
Diagnosis Procedure
SUNLOAD SENSOR
Description
COMPONENT DESCRIPTION
-
The sunload sensor (1) is installed to the right side of instrument panel assembly.
-
The sunload sensor converts the sunload amount (illuminance) into the current value with the photodiode. The A/C auto amp. calculates this
current value to the voltage and inputs it.
SUNLOAD AMOUNT CORRECTION
-
The A/C auto amp. inputs the sunload amount detected with the sunload sensor.
-
Perform the correction of the sunload amount detected with the sunload sensor for each air conditioner control.
-
When the sunload amount suddenly changes, for example when entering a tunnel, perform the correction so that the recognition sunload amount of
the A/C auto amp. changes slowly.
SUNLOAD SENSOR
Diagnosis Procedure
1.CHECK SUNLOAD SENSOR POWER SUPPLY CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect the sunload sensor connector.
3. Turn the ignition switch ON.
4. Check voltage between sunload sensor harness connector and the ground.
Is the inspection result normal?
YES - GO TO 2.
NO - GO TO 4.
2.CHECK SUNLOAD SENSOR GROUND CIRCUIT CONTINUITY
1. Turn the ignition switch OFF.
2. Disconnect the A/C auto amp. connector.
3. Check continuity between sunload sensor harness connector and A/C auto amp. harness connector.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair the harnesses or connectors.
3.CHECK SUNLOAD SENSOR
1. Connect the sunload sensor connector.