Cube L4-1.8L (MR18DE) (2010)
Clutch Fluid: Service and Repair
Air Bleeding Procedure
CLUTCH FLUID
Air Bleeding Procedure
CAUTION:
-
Keep painted surface on the body or other parts free of clutch fluid. If it spills, wipe up immediately and wash the affected area with
water.
-
Monitor clutch fluid level in reservoir tank so as not to empty the tank.
NOTE:
Do not use a vacuum assist or any other type of power bleeder on this system. Use of a vacuum assist or power bleeder will not purge all the air from
the system.
1. Fill reservoir tank with new clutch fluid.
CAUTION:
Never reuse drained clutch fluid.
2. Connect a transparent vinyl hose to air bleeder of bleeding connector (1).
3. "Depress" and "release" the clutch pedal slowly and fully 15 times at an interval of 2 to 3 seconds and release the clutch pedal.
4. Press the lock pin (1) into the bleeding connector (2), and maintain the position.
CAUTION:
Since the inside of clutch tube is under hydraulic pressure, hold the tube to prevent it from getting disconnected.
5. Slide bleeding connector (1) in the direction of the arrow as shown in the figure.