Cube L4-1.8L (MR18DE) (2010)
Body Control Module: Testing and Inspection
Additional Service When Replacing Control Unit (BCM)
With Intelligent Key System
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description
BEFORE REPLACEMENT
When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
AFTER REPLACEMENT
CAUTION:
-
When replacing BCM, you must perform "WRITE CONFIGURATION" with CONSULT-III.
- Complete the procedure of "WRITE CONFIGURATION" in order.
- If you set incorrect "WRITE CONFIGURATION", incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
-
When replacing BCM, perform the system initialization (NATS).
Without Intelligent Key System
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description
BEFORE REPLACEMENT
When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
AFTER REPLACEMENT
CAUTION:
-
When replacing BCM, you must perform "WRITE CONFIGURATION" with CONSULT-III.
- Complete the procedure of "WRITE CONFIGURATION" in order.
- If you set incorrect "WRITE CONFIGURATION", incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
-
When replacing BCM, perform the system initialization (NATS).
With Intelligent Key System
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Special Repair Requirement
1.SAVING VEHICLE SPECIFICATION
CONSULT-III Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. See: Body and Frame/Body Control Systems/Testing and
Inspection/Programming and Relearning/Configuration (BCM)/Description/With Intelligent Key System
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
- GO TO 2.
2.REPLACE BCM
Replace BCM. See: Service and Repair/With Intelligent Key System/Exploded View.