Cube L4-1.8L (MR18DE) (2010)
1. Locate retaining clip access hole (LH/RH) and insert a 5.0 mm (0.197 in) diameter, blunt-ended tool (A).
NOTE:
When inserting a blunt-ended tool (A), check that the tool contacts torsion spring (1). By pressing torsion spring, connection of driver air bag module
is disengaged.
2. Pull out the driver air bag module assembly.
3. Disconnect the driver air bag module harness connector.
CAUTION:
-
For installing/removing the driver air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and
remove connector.
-
Install the connector with lock raised, and push lock into the connector.
-
After installing the connector, check that the lock is pushed securely into it.
4. Remove the driver air bag module.
CAUTION:
-
Always place the driver air bag module with pad side facing upward.
Arrow Indicates : Upward